Diving

The RMG Dummy Connectors are manufactured in both Low Pressure (LP) and High Pressure (HP). Instead of a cable, it is solid rubber on the end (about 3 in. long rubber).

Features

• Standard rubber molded dummy connector

• Mated Pressure Rating: 20,000 psi (male pin contact required) or < 4,000 PSI (male pin contact not required)

• Female socket

• Number of Contacts: 3

• Mates with: RMG-3-MP and XSG-3-BCL

• Locking Sleeve:  G-FLS-D

 Specifications

• Material: Special neoprene, molded

• Voltage Rating: 600 VDC-contact factory for higher voltage requirements

The Rubber Molded Dummy Connector mates with RMG-3-FS.

Features

• Standard rubber molded dummy connector

• Low pressure

• Mates with: RMG-3-FS

 Specifications

• Material: Special neoprene, molded

Specifications

• Dimensions:

  • 7.5 in. x 50 ft.

  • 7.5 in. x 100 ft.

• Max Umbilical Inside Diameter: 1.75 in.

• 2 in. velcro edge closure and end snaps

• Fits:

  • Standard 3-part diving umbilical (air, pneumo, and comms)

  • Standard 4-part diving umbilical with hot water hose (air, pneumo, comms, and hot water)

  • 5-part diving umbilical with max inside diameter of 1.75 in.

• Material: Vinyl coated fabric, UV and mildew resistant

• Colors:

  • Green

  • Red

  • Yellow
     

Note: If you have a 5-Part Diving Umbilical, you will need to confirm your umbilical diameter does not exceed 1.75 in. This umbilical sheath has been confirmed to fit a standard 3-Part Diving Umbilical (Air, Pneumo, and Comms) and 4-Part Diving Umbilical with Hot Water Hose (Air, Pneumo, Comms, and Hot Water).